Advertisement
Quick Links
Advertisement
Related Manuals for Oliver 10014.201
Summary of Contents for Oliver 10014.201
- Page 1 Retro Fit Instructions for Wixey DRO Oliver Model 10014.201...
- Page 2 Model 10014.201 Note: You may be able to use pieces that are already installed with the original DRO. Step 1: Remove the screw from DRO, and fix the upper plate on the DRO as shown below. Wixey WR510S*1pcs 174977-904 Upper positioning plate*1pcs...
- Page 3 Model 10014.201 Step 2: Use a 4mm hex wrench and attach the magnetic strip, lock screw, flat washer and CAP screw on the bracket in the order as below. Magnetic strip*1 SET Flat 5.2*12*1.5*1 pc Lock screw M5*0.8P*1 pc 174976-904 lower bracket*1pc CAP Screw M5*0.8P*15L*1...
- Page 4 Model 10014.201 Step 3: Use 5mm hex wrench to lock the assembly from step 2 on the machine as below. SET screw M10*1.5P*30L*1pc Flat washer 10.3*22*2.0t*1 pc Hex nut M10*1.5P(17B*8H)*1 pc Set Screw Hex nut M10*1.5P(17B*8H)*1 pc M10*1.5P*30L*1pc Flat washer 10.3*22*2.0t*1 pc...
- Page 5 Model 10014.201 Step 4: Slide the DRO onto the magnetic strip Magnetic strip assembly*1 SET DRO (Wixey WR510S)*1pc...
- Page 6 Model 10014.201 Step 5: Use a 5mm hex wrench to fix the upper position plate on the machine Flat washer 6.2*13*1.5t*1 pc CAP screw M6*1.0P*30*1pc CAP screw M6*1.0P*30*1pc Flat washer 6.2*13*1.5t*1 pc...
- Page 7 Model 10014.201 Step 6: lower the head down to its lowest point (6mm), and adjust the DRO to correspond with 6mm on the scale by adjusting the screw. When the DRO shows zero (As the scale), tighten the screw. Adjusting DRO up/down...