Table of Contents
Advertisement
RX-SO8VBK
RX-5O09VTN
Before Starting
Page 8
1-10 (No. 20376)
Connecting Speakers
You can connect the following combinations of speakers:
¢ two pairs of front speakers to produce normal stereo sound
* one pair of rear speakers to produce the surround sound effect
*
one center speaker for more effective surround sound
A CAUTION! Use speakers with the impedance marked near the terminals.
To connect each speaker, follow these steps:
Step 1 Open each terminal on the back of the receiver and insert
the end of the speaker wire,
as shown.
Step 2 Close the terminals to clamp the speaker wires in place, as shown.
NOTE: Use the wire supplied with the speakers.
Connect the front speakers to the FRONT SPEAKERS terminals.
Up to two sets of front
Speakers can be connected.
e n e ee ct
nent
tener
ner
eran
tense
anya
inane
Connecting the Rear
Speokers and Center
speaker to the CENTER SPEAKER terminals.
Speakers
RX-SO8VBK
RX-509VTN
Connect the rear speakers to the SURROUND SPEAKERS terminals. Connect the center
IMPORTANT! Check the position of the CENTER SPEAKER switch on the back of the
receiver. When the center speaker is connected fo the receiver, set the switch to
the "in" position (m). When no center speaker is connected to the CENTER
SPEAKER terminals, set the switch to the "out" position (Ml). If the switch is in the
wrong position, either you will hear no sound from the center speaker, or you
will get an incorrect sound effect.
AX CAUTION! You must turn the POWER switch OFF before setting the CENTER
SPEAKER switch either "in" or "out".
IMPORTANT! When the CENTER SPEAKER switch is set to the "in" (m) position,
make sure that both rear speakers are connected. Otehrwise, you will hear no
sound from the rear speakers.
NOTE: It is recommended to use an antimagnetic speaker for the center speaker.
Position the center speaker near the TV monitor.
Increasing Power for the
To increase power for the center speaker, you can use a separate amplifier.
Center Speaker
Step 1
Connect the input terminals of the power amplifier to the CENTER OUT terminal on
the back of the receiver.
Step 2
Connect the center speaker to the speaker terminals of the connected amplifier.
IMPORTANT! Make sure the CENTER SPEAKER switch is in the "out" position (Ml).
CENTER
SPEAKER
Page 9
(No. 20376) 1-11
Advertisement
Table of Contents
