Ikegami TM14-17R Service Manual page 5

1. Comply with caution and safety related notes located
on the shield case in the receiver.
2. WARNING
Any alteration should not be made in the design or
circuitry of this receiver.
Any design alterations or additions may alter the
safety characteristic of this receiver and potentially
create a hazardous situation for the user.
Any design alterations or additions will void the
manufacturer's warranty and will further relieve the
manufacture of responsibility for personal injury or
property damage resulting therefrom ..
3. CRT
The picture tube in this receiver employs integral
implosion protection. Replace with a tube of the
same type number for continued safety.
4. X-RADIATION AND HIGH VOLTAGE LIMITS
The primary source of potential X-radiation in solid
state receivers is the picture tube ..
The picture tube is specially constructed to prohibit
X-radiation emissions. For continued X-radiation
protection, the replacement tube must be the same
type as the original.
The shields and mounting hardware for picture tubes
have an X-radiation protection function and must be
properly in place.
High voltage must be checked each time any service
is required that involves B+, horizontal deflection or
high voltage.
Where used, X-radiation protection circuits must be
checked for proper operation each time the
X-radiation protection circuit is serviced ..
iv
Refer to the warning label on the shield case in the
receiver and the schematic in the manual and, where
used, X-radiation protection circuits specifications.
High voltage is maintained within specified limits by
the use of close tolerance safety related components
/adjustments in the high voltage circuit.
If high
voltage exceeds specified limits, check each
component specified on the schematic diagram and
take necessary corrective action.
5. PRODUCT SAFETY NOTICE
Many electrical and mechanical parts is receiver sets
have special safety-related characteristics.. There
characteristics are often not evident from visual
inspection nor can the protection afforded by them
necessarily be obtained by using replacement
components rated for higher voltage, wattage, etc.
Replacement parts which have these special safety
characteristics are identified in this manual.
Electrical components having such features are
identified by (
* )
on the parts list and the schematic
diagram in this manual.
The use of a substitute replacement which does not
have the same safety characteristics as the
recommended replacement part shown in the parts list
in this manual may create shock, fire, or other
hazards.
Product Safety is continuously under review and new
instructions are issued from time to time ..
For the latest information always consult the current
lkegaml Service Data..
A subscription to, on
additional copies of, lkegami Service Data may be
obtained at a nominal charge from NY-lkegami.