Page 2
Manual Windbit Legal Notice Warranty This publication is subject to change. Teldat S.A. offers no warranty whatsoever for information contained in this manual. Teldat S.A. is not liable for any direct, indirect, collateral, consequential or any other damage connected to the deliv- ery, supply or use of this manual.
1.7 Technical support Windbit offers technical support. Device software can be upgraded on a regular basis for maintenance purposes and in case new features are developed. Contact information: Web: http://www.windbit.com/ Email: support@windbit.com...
Together, the hardware innovation and software evolution of this device offers customers a high level of productivity and a very good user experience. It is a carrier-grade device that can easily migrate to SDWAN or secure services offering all Windbit SDWAN benefits to IT managers.
3 Components and Power Supply Windbit Chapter 3 Components and Power Supply The following chapter provides detailed information on the chassis of the Ares-C640 router and its components. This information includes: • Components • Information on installation • Cooling • Power supply •...
Page 9
3 Components and Power Supply Windbit For more information on the USB connectors, refer to: USB 3.0 connector on page 22 - on page USB interface on page 24 4x 1/10 Gigabit Ethernet SFP/SFP+ ports. For more information on the Gigabit Ehternet SFP/SFP+ interfaces, refer to:...
3 Components and Power Supply Windbit Ethernet RJ45 interface LEDs Fig. 4: The table below provides information on the LEDs associated with the RJ45 Ethernet interfaces: RJ45 Ethernet interface LED indicators Description Left (Green) - Steady: 1000M link established - Blinking: Transferring data...
3 Components and Power Supply Windbit ON/OFF button. For further information on how the ON/OFF button works, please see Power ON/ OFF button on page 11. Power Supply Units. Refer to Power source on page 10 for more information on Power Connection and...
3 Components and Power Supply Windbit 3.2.3 19'' Rack installation Ares-C640 devices can be installed in a 19” rack. The Rack Mounting Kit consists of two brackets, eight screws and six rack screws with cage nuts. To install the kit, follow these steps: •...
3 Components and Power Supply Windbit 3.2.3.1 Ground the router Ensure the rack on which the Ares-C640 is to be mounted is properly grounded in compliance with ETSI ETS 300 253. Verify that there is a good electrical connec- tion to the grounding point on the rack (no paint or isolation surface treatment).
3 Components and Power Supply Windbit Fig. 11: Airflow Note Maintain a minimum clearance of 100mm around the device for air circulation. 3.4 Power source The Ares-C640 router is powered through two swappable Power Supply Modules, labeled as PWR1 and PWR2, that operate simultaneously.
3 Components and Power Supply Windbit Fig. 13: PSU detail • Disconnect the power cable from the Power Supply Module (1). • Unscrew the screws (2) securing the Power Supply Module to the chassis. • Hold the handle (3) with one hand and place the other hand under the module to support its weight.
3 Components and Power Supply Windbit 3.5.1 Switching off the device • Press and hold the ON/OFF button for at least 4 seconds to start the shutdown process. • When the process is complete, the Ares-C640 will beep. • The Ares-C640 can now be safely disconnected from the AC power.
3 Components and Power Supply Windbit 3.7.1 SFP/SFP+ connections (ETH0 to ETH3) Four 10 Gigabit Ethernet SFP+ interfaces are available on the Ares-C640, supporting 10GBase-R, labeled as ETH0 to ETH3, for Multi-WAN service connections. WAN connectors Fig. 16: Note Do not install or remove the SFP/SFP+ transceiver module with fiber-optic cables still attached to it. Do- ing so may damage cables, cable connectors, or the optical interfaces and may interfere with the trans- ceiver module latching properly into its socket connector.
3 Components and Power Supply Windbit Note Do not install or remove the SFP transceiver module with fiber-optic cables still attached to it. Doing so may damage cables, cable connectors, or the optical interfaces and may interfere with the transceiver module latching properly into its socket connector.
4 Compliance Windbit Chapter 4 Compliance 4.1 Manufacturer information Brand Windbit Manufacturer Teldat S.A. Country Spain Postal Address Isaac Newton, 10 Parque Tecnológico de Madrid, 28760 Tres Cantos, Madrid, Spain International Phone +34 91 807 65 65 4.2 Risk identification WARNING: Signal word used to designate a potentially dangerous situation that may cause severe injuries or death if not avoided.
4 Compliance Windbit 4.4 WEEE information The crossed-out wheelie bin symbol indicates that the device must be disposed of separately from normal domestic waste in an appropriate waste disposal facility when it comes to the end of its useful life.
Parlamento Europeo y del Consejo. The full text of the EU declaration of conformity and additional product documentation is available at the following In- ternet address: http://www.windbit.com/conformity This equipment is in conformity with the CE procedures and marking. 4.7 Laser product...
Technical Information Windbit Appendix A Technical Information A.1 Troubleshooting The following table can help you solve problems when installing the device. If you cannot solve the problem, contact your dealer for more information. Symptom Solution None of the LEDs light up on Check the power supply to the router (power source, ON/OFF switch, main power the router.
The Ares-C640 router family can be updated to new versions. Please contact your dealer for further details on new releases. There are several ways to update a Windbit router. For further information, please see manual: “Windbit Dm929-I OSDx Command Line Interface” , Firmware upgrade section.
Technical Information Windbit A.5.8 Dimensions and weight TYPE Desktop / chassis for a 1 U high Rack mount enclosure. LENGTH x WIDTH x HEIGHT 430 x 444 x 44 mm 430 x 483 x 44 mm (with backets) WEIGHT 6.675 kg.
Need help?
Do you have a question about the Ares C640 and is the answer not in the manual?
Questions and answers