Summary of Contents for DATATEC Y.I.C. TECHNOLOGIES EMProbe
- Page 1 EMProbe Solution Comprehensive Setup Guide Ihr Ansprechpartner / Your Partner: dataTec AG E-Mail: info@datatec.eu >>> www.datatec.eu...
- Page 2 Disclaimer Warranty The material contained within this user manual is provided as is and is subject to being changed, without notice, in future editions. Further to the maximum extent permitted by applicable law, Y.I.C. Technologies disclaims all warranties, either expressed or implied, with regard to this user manual and any information contained herein, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose.
- Page 3 Components Box Contents EMProbe Solution The robotic arm that will be holding the Near Field Magician Probes during a scan. Power Supply The power supply for the Magician The YIC Technologies Near Field Probe set. NFPSet Comes with 5 probes. This connects the PC (laptop or desktop) to the USB Cable Magician.
-
Page 4: Installation And Hardware Setup
Installation and Hardware Setup To safely and accurately setup the EMProbe solution, please refer closely to the following information regarding the full installation process. 1. Install communication software for the spectrum analyzer: You must determine which software to install from the manufacturer’s website. For SCPI controlled spectrum analyzers, any software which installs NI-VISA can be used. - Page 5 RIGOL UltraSigma Recommended to use with RIGOL spectrum analyzers. Some RIGOL analyzers (such as the RSA5000) require additional downloads to use with this software. Please refer to the user manual for your spectrum analyzer. Install the EMViewer software application: You can download the EMViewer software by going to the following linked page: https://yictechnologies.com/emviewer/ Install the EMViewer software by running the downloaded setup application.
-
Page 6: Establish A Connection
EMProbe Connections: RF Connection: connect the SMA side of the RF Cable to the probe held by the Magician and the N Type side to the spectrum analyzer (RF Input). USB Connection: connect the Magician to a PC using the USB cable. Establish a Connection After you have connected the Magician to the PC and powered it on, wait at least 30 seconds for the software to detect it. -
Page 7: Technical Support
A detailed description of the problem, including screenshots and video footage. www.yictechnologies.com support@yictechnologies.com Copyright © Y.I.C. Technologies Ltd All rights reserved. Sentinel House, Ancells Business Park, Harvest Crescent, Fleet, Hampshire, GU51 2UZ, UK Ihr Ansprechpartner / Your Partner: dataTec AG E-Mail: info@datatec.eu >>> www.datatec.eu...