Using The Electronic Minute Timer; Starting A Function - Whirlpool RMC275PD Use And Care Manual

ilii , ii _ :_!!!i:;i_ iii_ii _i_i_i_ii 'ii_ _iiiiiiiii i11 ili'_ _iiii_ _ :_i_!_i!_ _ iii _ !ii!i_ ,_C_1:;_i_i_i:_ ''_,O _i_iiiii_ iiii _C_
iii'!iJli iiilii _ii_i_i iii_ i_i,:i_l::,_ili!i_ iiil _iiiiiii ;i ; _ _ ii_,_ilili_ _iiii _'_
The Minute Timer does not start or stop the oven. It
works like a kitchen timer. It can be set in hours and
minutes up to 12 hours 59 minutes. The Minute Timer
will display minutes and seconds for settings under
1 hour. You will hear four 1-second tones when the set
time is up unless reminder tones are disabled.
When the time is up:
You will hear four 1-second tones, then four
1-second reminder tones every minute until you
press TIMER OFF.
YOU SEE
1. PRESS
TIMER I TIMER'}
SET I OFF J
YOU SEE
2. Set time.
Press the "up" (A) or "down" (V) pad(s) until the
correct time shows on the display.
PRESS YOU SEE
Z_ z_
iv I!_ZJ
(example for 10 minutes)
3. PRESS YOU SEE
OR
The Minute Timer will begin counting down
immediately after the timer is started.
(display counts down)
4. PRESS YOU SEE
(time of day)
To cancel the Minute Timer:
PRESS YOU SEE
(time of day)
Disabling the timer reminder tones:
To disable the reminder tones, press and hold TIMER
SET for 5 seconds.
To enable the tones, follow the same step.
After disabling or enabling reminder tones, a single
tone will sound to tell you the signals have been
changed. "nAg" and "OFF" or "nAg" and "On" will
appear on the display. Press START/ENTER for return
to the Minute Timer countdown or the time of day dis-
play.
After programming a function, you must press
START/ENTER to start the function. If you
do not press START/ENTER within
5 seconds of programming, "START?" will
show on the display as a reminder. The control will
return to time of day mode after 5 minutes if
START/ENTER is not pressed.