Pioneer CT-W851R Operating Instructions Manual page 15

RECORONG |
2. Press the recording { @} button.
| AUTO BLE TUNING
When tuning DECK II (or 1).
(1) 1
2
1. Load a tape in DECK I (or }).
® The AUTO BLE does not work when the erasure prevention
tabs of the loaded cassette tape have been broken off.
2. Press the BLE button of DECK II {or 1).
The (1) tor (1) indicator will flash in the AUTO
BLE display for about 30 seconds, after which it will light
steadily.
The tape will be forwarded for approximately one second after
pressing the start button so that recording will start from the
recordable portion of the tape.
The operation is completed when the start position is resumed.
When tuning both decks in sequence
(CT-W851R/CT-W801R/CT-W701R only)
1. Load tapes in both decks.
2. Press the RELAY/SKIP button, turning the RELAY/SKIP
indicator on.
3. Press the BLE button of DECK I.
AUTO BLE tuning starts from DECK | to DECK tt.
® If the BLE button of DECK If is pressed, the tuning will stop
after only DECK Il is tuned.
®
A tuning signal will be recorded on the cassette in the
cassette deck when using AUTO BLE. The music and other
infomation already recorded on this cassette will be erased
from the point where tuning starts.
fez} 9
Lights ee
{Flashes
ee}
Lights
To stop AUTO BLE tuning
DECK | tuning
DECK I tuned
DECK II tuning
DECK Il tuned
To reset a tuned condition
Press the BLE button again.
Error display
The following illustrates the operation:
{Operation completed within approximately 30 seconds)
— : —
Display
Counter isol,
indicator Pattern display
START mem a
Lith lata
(Normal
counter)
—
® Tce
a ar |
* Adjusting recording bias.
4
at ro
sea ee
ey
ia
@ re 4
a Ee ah
"@
* Adjusting recording level
{sensitivity).
| @
ure
@®
is
®
| J
* Adjusting recording equalizer.
STOP mA wey a
LPR LDL
END {Return to
normal
counter}
15
<RRB1120>
En