Note: Revision letters (A, B, C, D etc.) after model numbers have been omitted as they do not affect the setup,
operating and maintenance instructions of a particular jack unless otherwise noted.
IMPORTANT: READ THESE INSTRUCTIONS BEFORE OPERATING
BEFORE
USING
THIS
COMPLETELY
AND
THOROUGHLY,
OPERATING
PROCEDURES,
MAINTENANCE REQUIREMENTS. FAILURE TO DO SO COULD
CAUSE
ACCIDENTS RESULTING IN SERIOUS OR FATAL
PERSONAL INJURY AND/OR PROPERTY DAMAGE.
The use of hydraulic shop presses is subject to certain hazards
that cannot be prevented by mechanical means, but only by the
exercise of intelligence, care, and common sense. It is therefore
essential to have owners and personnel involved in the use and
operation of equipment who are careful, competent, trained,
and qualified in the safe operation of the equipment and its
proper use. Examples of hazards are part breakage resulting in
flying parts, slipping and dropping of components to be pressed
caused primarily by not using guards or protective blankets over
Finished Installation #1
PROFESSIONAL LIFTING EQUIPMENT
MODEL 78035 PRESS GUARD FOR 25 TON PRESS
SETUP & OPERATING INSTRUCTIONS
PRESS,
READ
THIS
UNDERSTAND
SAFETY
WARNINGS AND
FINISHED INSTALLATION
®
MANUAL
the components, improperly securing adjustments on the press,
ITS
improperly securing components to be pressed, overloading and
off-center loads.
It is the responsibility of the owner to make sure all personnel read
this manual prior to using this device. It is also the responsibility of
the device owner to keep this manual intact and in a convenient
location for all to see and read. If the manual is lost or not legible,
contact Norco Industries, Inc. for a free replacement. If the operator
is not fluent in English, the product and safety instructions shall be
read to and discussed with the operator in the operator's native
language by the purchaser/ owner or his designee, making sure
that the operator comprehends its contents.
This press is covered by a Limited Lifetime Warranty. For details
see the back cover of Norco's product catalog.
Finished Installation #2
78035
WARRANTY
78035