Table of Contents
Advertisement
Appendix - User Interface Display
Run Mode Screens
Run mode screens are divided into two sections: heat
zone operation and error reports. While in Setup mode,
press
to enter Run mode.
Heat Run Screen
The Heat Run screen displays information for the two or
four heat zones. See F
IG
zone. For each zone, the icon on the upper right is pres
ent if the zone is enabled, otherwise the space is blank.
The temperature unit is shown in the upper right of the
menu bar. An alarm icon displays in the bottom right if
there is an alarm or warning on a heat zone, which indi
cates that the soft key will clear the alarm or warning.
System component
being
Zone
number
F
. 8: Heat Run Screen - Ram A
IG
From the Heat Run screen, users can view heat zone
information for each zone, change setpoints, put heat
zones into Setback mode, and turn heaters on and off
for enabled heat zones.
Setback Mode
To put heaters into setback mode for enabled heat
zones, press
. The setpoint for each zone will be
decreased by the setback amount set on Heater Sys
tem Setup Screen, page 21. To cancel the setback
mode, press
again.
24
. 8 for information about each
Zone set point
Zone temperature
Change Zone Temperature Setting
Press
to access the fields to make changes. Use
the navigation buttons to move to the desired heat zone.
Press
to edit the heat zone. Press
enter the new temperature, and then press
save the change. Press
Report Screens
The five Report screens display a chronological list of
the most recent 20 errors. See Alarm Codes and Trou
bleshooting, page 9, for details regarding each alarm
code.
Icon
Function
Chronological order of errors as they
occur.
Date when error occurred.
Time when error occurred.
Error code.
Press
to scroll through the five report
screens.
F
. 9: Report Screen
IG
to
to
to exit edit mode.
3A0100H
Advertisement
Table of Contents
