Draining Water Out After End Of Cycle; Stand-By Option - AEG L6FBG51470 User Manual

DAILY USE
When you activate the appliance again, the display show the
end of the last selected programme. Turn the programme dial to
set a new cycle.
2. Remove the laundry from the appliance.
3. Make sure that the drum is empty.
4. Keep the door and the detergent dispenser slightly ajar to
prevent mildew and odours.
5. Close the water tap.

13.13 Draining water out after end of cycle

If you have chosen a programme or an option that does not empty
out the water of the last rinse, the programme is completed, but:
• The display shows the door locked indicator
• The drum still turns at regular intervals to prevent the creases in
the laundry.
• The door stays locked.
• You must drain the water to open the door:
1. If necessary, touch the Schleudern button to decrease the spin
speed proposed by the appliance.
2. Press Start/Pause to continue the cycle
3. When the programme is completed and the door locked indicator
goes off, you can open the door.
4. Press the Ein /Aus button a few seconds to deactivate the
appliance.
In any case, the appliance empties the water out automatically
after approximately 18 hours.

13.14 Stand-by option

The Stand-by function automatically deactivates the appliance to
decrease the energy consumption when:
42/68