AEG COMPETENCE 5150 B Operating Instructions Manual page 24

Secondary
oven
Main oven
Cleaning the
lamp cover or
replacing the
oven lamp
Oven
lighting
It should not nornnally be necessary to clean the catalytic roof in
water. If you feel you would like to do so, take out the roof and
wash in warm, soapy water, followed by rinsing in clear water.
If your oven has a catalytic roof, sides and back panel either as
standard equipment or if you have bought these parts separately
and fitted them, then the foilowing information will be of interest to
you.
The liners help to keep the oven cleaner as they clean themselves
to a great extent during roasting and baking at temperatures
above 200 °C. As cleaning may be improved by exposure to a
higher temperature it may be necessary to run the oven at 250 °C
for 1 or 2 hours per week. Before carrying out such a heat cycle,
remove all oven equipment and make sure that you have cleaned
the unlined surfaces to prevent any soil from baking on. For Isolat¬
ed stubborn stains use a soft brush and very hot soapy water.
Never use abrasive cleaners or scouring powders.
WARNING! Isolate the oven from supply before replacing
oven lamp.
To clean the glass cover or change the oven lamp, the glass
cover can be taken off by turning it anti-clockwise.
You can
illuminate
the oven for cleaning. To do this, turn the
oven control knob or the cooking method selector to the lamp po¬
sition g)-
■ Thorough cleaning
For thorough cleaning, you can remove various parts:
24