Advertisement
5208 8¢2873
e208? BETO
Maintenance Gear
Counter Gear
Odometer
Matchimarks "tL
set,
aesgr Reset Knob:
Matchmarks
Adjust Each
sesa72
i
sess
Position
Meter Illumination Control System
INSPECT LIGHT CONTROL
RHEOSTAT
(a) Connect terminals 1 and 3 through a 3.4 W t
bulb.
(b)
Connect the positive (+) lead from the battery
terminal 1 and negative (-) lead to terminal 2.
(c)_ Turn the rheostat dial fully down to check that
test bulb goes out.
(d) Gradually turn the rheostat dial up to check
the test bulb brightness changes
from
dark
bright.
If operation is not as specified, replace the rheostat.
Bulb Check System
INSPECT BULB CHECK RELAY
tive (-) lead to terminal B, check that the test bi
does not light up.
terminal A, check that the test bulb lights up.
If operation is not as specified, replace the relay.
IF REPLACING SPEEDOMETER
(w/ Oil Change Warning System)
NOTICE;
When
removing
the speedometer,
do
push the maintenance gear nor reset knob to avoid
separation of the maintenance gear from the cour
(a) Mark on the maintenance gear where the
gears are engaged.
(b)
Confirm
the odometer
reading of a new s¥
meter to 000000".
(c) Turn the maintenance gear clockwise to
marked place with pressing it.
+ When installing the new meter, be careful not
push the reset knob.
BE-49
Ignition Switch
J/B and R/B No.1
* Fuse DEFOG
* Fuse GAUGE
Defogger Switch
Back Door Glass
* Defogger Wire
Wiring and Connector Diagrams
leesis
[eto2.8 s.s2 esee7
Ignition Switch
Defogger Switch
Rear Window
Defogger Wire
Defogger Switch
Defogger Relay
=e!
AR,
Advertisement
