Advertisement
Figure 3-3: Installing Camera
4. Connect the network access port into the
interface using the tool, as shown in figure
3-4. Plug in the power supply and other
interface by using the wrench to pass them
through the rubber stoppers.
Figure 3-4: Installing Housing
Note
The camera has two outlets for the cables. If using
●
the top outlet, a hole should be drilled for threading
the cable.
●
If using the side outlet, the installation sticker's gap
should align with the outlet rubber stopper.
5. Align the set screw with the direction arrow
on the base panel, then rotate the device
clockwise until it stops. Tighten the set screw
to lock the block, as seen in figure 3-5.
Figure 3-5: Installing Device
6. Connect the camera to a monitor, loosen the
screws of the support frame, then adjust the
three axes to position the camera to the
desired image. Tighten the screws to finalize
adjustments. As shown in figure 3-6.
Figure 3-6: Adjusting Lens
Note
●
While adjusting the lens, the image may blur; set the
focus value in Settings > Lens Control in the camera's
web interface.
7. Arrange the camera cable using the over-line
buckle, then attach the dome cover with the
hex wrench, as shown in figure 3-7
Figure 3-7: Attaching Dome Cover
4. Device Ports
Note:
Different devices may have different ports and
multi-head cables; please refer to the actual product.
Advertisement
