Related Manuals for EDI CTT-2
Summary of Contents for EDI CTT-2
- Page 1 CTT-2 Operation Manual V1.01 04/16/14 Contents Introduction Swept frequency testing Spot frequency testing Leakage test Indicator LED's Data format selection Baud rates Command list Calibration Specifications Warranty CTT-2 Manual V1.01...
- Page 2 100 ohms to over 10 megohms. Preliminary setup and test Connect a terminal to the CTT-2. Set the terminal for a Baud rate of 9600, 8 data bits, 1 stop bit, no parity, and no handshake. The supplied terminal program, DSTS_terminal.exe, is preset to these values.
- Page 3 F= 100000, Z = 257 instead of the CSV that will only return 100000,257. The 'p' command switches to CSV data. To go back to the descriptive data, type 'P'. CTT-2 Manual V1.01...
- Page 4 The 'bsxxxxx' command stores the new Baud rate in eeprom but does not change the rate until the next time the power is turned off and on. 8 CTT-2 Command list: 'Brxxxxx' sets baud rate. Only 9600, 19200, 38400 allowed.
- Page 5 Increase 'Co' to lower the reading, decrease it to increase the reading. The 'Co' value must be between 1 and 6. If a 'Co' value over 6 is required, the CTT-2 should be returned to the factory for repair.
- Page 6 Unit will be repaired free of charge for one year from date of purchase providing there is no water damage or other evidence of improper use or handling. Purchaser must ship unit prepaid to address below; EDI will pay the return freight for shipments within the contiguous United States.
Need help?
Do you have a question about the CTT-2 and is the answer not in the manual?
Questions and answers