If The Machine Does Not Work As You Want.28 - Savin 9920DP Operating Instructions Manual

IF THE MACHINE DOES NOT WORK AS YOU WANT
IF THE MACHINE DOES NOT WORK AS YOU WANT
♦If an error message is displayed
This section describes typical error messages. If an error message not
described below is displayed, follow the instructions on the display.
■Message
■State/Cause
■Action
□ "Please wait" is dis¬
played.
• This message appears when
you turn on the main switch,
add toner, or replace the PCU.
■ Wait for a while.
• You can enter copy job settings dur¬
ing the warm-up period.
"Auto Start"
=>
See "Copy Refer¬
ence."
■ When you turn on the main switch, it
takes 30 seconds for the machine to
enter the ready condition.
■ The machine initialize about 3min-
utes after adding toner.
• The machine initialize about 2 min¬
utes after replacing the PCU.
□ Reset the Duplex
Tray.
• The duplex tray is pulled out.
• Reset the duplex tray.
"GUIDE TO COMPONENTS"
=>
See page 3.
□
Please input user
code, then press
®
key.
• The machine is set to the User
Code mode.
■ Enter your user code.
=>
See page 11.
□
Set Key Counter.
• The key counter or card is not
set.
■ Set the key card or counter.
♦Others
■State
■Cause
■Action
□ The panel display is
turned off.
■ The machine is in the Energy
Save mode.
■ Press the
Clear Modes/Energy
Saver
key.
■ The main switch is turned off.
■ Turn on the main switch.
□ The machine is not
turned on even though
you turn on the main
switch.
■ The AC switch is turned off.
■ Turn on the AC switch.
=> See page 3.
28