Short M6 Bolt
M6 x 1 x 14
Qty. 16
A
ASSEMBLE THE HOPPER
Remove all hardware from packaging.
Gather all 4 hopper panels and the
hopper cone.
Place the cone on its side, with the front arrow
pointing either Left or Right. Attach both
face panels to the cone using (4) M6 Short Bolts
and (4) M6 Lock Nut. Hand tighten only.
Place a face panel on top of the cone and overlapping the side panels. Align the bolt holes
in the cone with the (2) lower holes in the face panel. Secure using (2) Short M6 Bolts and
(2) M6 Lock Nuts. Hand tighten only.
Side
Panel
Flip the hopper over and install the remaining face panel following the same procedure above.
OPTIONAL:
Stand the hopper upright with the cone flat on the floor. Align the bolt holes in the top (4) corners. Secure with (4) Short M6 Bolts and
(4) M6 Lock Nuts. Hand tighten only.
Instructions for Ranch Series 300lb Hopper
Thank you for your purchase of a Moultrie Ranch Series 300lb Hopper. Please read this sheet before operating
the unit. If you should have any questions about this product or any other Moultrie product, please contact us
using the information on the back of this sheet. Allow us to better serve you by activating your 1-year warranty
online at http://www.moultriefeeders.com/warranty .
M6 Lock Nut
M6 x 1
Qty. 16
Face Panel (x2)
Face Panels
Cone
Face
Panel
(2) Solar Panel Mounts are included with the kit. Install during this step if you choose to use them.
M6 Short Bolt
Short M8 Bolt
M8 x 1.25 x 14
Qty. 8
Side Panel (x2)
(Not included with Gravity Kit)
M6 Lock Nut
M8 Lock Nut
M8 x 1.25
Qty. 16
Top
Bottom
M6
Lock Nut
M6
Short Bolt
M6
Lock Nut
Solar Panel
Mount
M6 Short Bolt
Long M8 Bolt
M8 x 1.25 x 50
Qty. 8
Cone (x1)
(x4)
M6
Short Bolt
(x4)
M6 Lock Nut