Related Manuals for LifeSafety Power FLEXPOWER SD4
Summary of Contents for LifeSafety Power FLEXPOWER SD4
- Page 1 SD4, SD4P Installation Manual LifeSafety Power, LLC | PH 888.577.2898 | TechSupport@LifeSafetyPower.com P03-104 Rev A01...
-
Page 2: Table Of Contents
SD4 Installation Manual Table of Contents Regulatory Information Description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 The equipment discussed within this manual has been tested to the following standards: Specifications . - Page 3 THIS PAGE BLANK...
-
Page 4: Managed Distribution Module Overview
SD4 Installation Manual Managed Distribution Module Overview Fault Fault ... - Page 5 Managed Distribution Module Overview Voltage Buss Connectors Fault LED - Yellow These fastons are for connection to the B1, B2, and BR bus- The yellow Fault LED lights when the SD4 detects a fault condi- ses in the system . tion (including a tripped upper or lower limit - See the program- ming section for more information) .
-
Page 6: Connecting The Managed Distribution Module
SD4 Installation Manual Connecting the Managed Ditsribution Module Remove all AC and battery power from the system before adding or replacing any accessory board. Each of the B1, B2, BR, and FlexIO busses has two connectors. These connectors may be used interchangeably. Required Connections For example: FlexIO from the power supply may be connected Optional Connections... - Page 7 THIS PAGE BLANK...
-
Page 8: Using The Managed Distribution Module
SD4 Installation Manual Using the SD4 Managed Distribution Module This section discusses software programming of the SD4 board . It assumes a basic understanding of the NetLink software GUI interface . Consult the NetLink manual (P03-037) for more information on using the interface . Accessing the SD4 from the NetLink interface Current (A) - This column shows the measured current being drawn from the output terminals of the SD4 for... - Page 9 The NetLink's SD4 Status Page The SD4 Status Page...
-
Page 10: Programming
SD4 Installation Manual Programming the SD4 Managed Distribution Module From the Status page of the NetLink interface, click the "Program- Voltage Upper Limit (V) - This column allows setting an upper ming" button near the top left corner . This will open the SD4's voltage limit to trigger a fault for each zone . - Page 11 The Programming Page The SD4 Programming Page...
- Page 12 Conditions of Sale for this product, and in no case will LifeSafety Power or its distributors be liable for any incidental, indirect, or consequential damages arising from the sale, resale, use, or misuse of the product. Specifications are subject to change without notice.
Need help?
Do you have a question about the FLEXPOWER SD4 and is the answer not in the manual?
Questions and answers