•
Open the air inlet grille and take off air filter.
•
Clean the air filter with neutral detergent in lukewarm 40°C water
and allow to dry (not in direct sunlight).
•
Re-install the air filter into the inlet grille.
TROUBLESHOOTING
Troubles
Possible Causes
The unit does not
•
Water full
start when pressing
indicator lamp
power button.
blinks and water
tank is full.
•
Room
temperature is
higher than the
setting
temperature.
(Electric heating
mode)
•
Room
temperature is
lower that the
setting
temperature.
(Cooling mode)
The unit doesn't cool
enough.
Suggested
Remedies
•
Drain the water
out of the water
tank.
•
Adjust the
temperature.
Noisy.
E0 Code
Instruction manual
•
The doors or
•
Make sure all the
windows are not
windows and
closed.
doors are closed.
•
There are heat
•
Remove the heat
sources inside the
sources if
room.
possible.
•
Hot air exhaust
•
Connect or clean
hose is not
the hot air
connected or
exhaust hose.
blocked.
•
Reset the
•
Temperature
temperature.
setting is too high.
•
Clean the air inlet.
•
Air inlet in
blocked.
•
The ground is not
•
Place unit on a
level or not flat
flat, level ground
enough.
if possible.
•
The sound comes
from the flowing
of the refrigerant
inside the air
conditioner.
•
Room
•
Replace room
temperature
temperature
sensor failed.
sensor.
EN