Sinocare i3 Quick Start Manual

Continuous Glucose Monitoring System
Quick Start Guide
Sinocare i3 System Overview
Refer to your User's Manual for full System instructions and information
Sensor Kit
Sep Up Mobile App
1
Step 1: Install CGM App
Download the Sinocare i3 CGM
APP from App Store
2
Prepare Sensor Applicator
Step 1: Check SN Codes to Match
The Sensor Pack and the
Transmitter Pack are
packed together, and they
have the same SN codes.
Check the SN codes to
match before pairing your
Sensor with the transmitter.
Step 2: Pair the Transmitter
a.Bring your App and make sure to turn Bluetooth on.
b.Scan the QR Code on the Sensor Pack using your App.
c.Tap "Bind" on the bottom when it turns to blue.
d.Pairing happens automatically. Keep the App open and keep it within 20
feet while you proceed to the next step.
XXXXXXXX
YYYY-MM-DD
Please scan
the QR code
YYYY-MM-DD
on the above
XXXXXXXXX
i3
Sensor Pack
Button
Safety Switch
Applicator
Sensor
(inside)
Transmitter Pack
Transmitter
Transmitter Tray
Step 2: Login to Your Sinocare i3 Account
a.Login if you already have an account.
b.Tap "Create a new account" on the bottom if you are new to the
system. The App will walk you through informational videos and
screens. Tap "Next" to proceed until it brings you to the Scanning
QR Code page. Keep your App open throughout the whole time.
SN codes
must match
i3 Sensor Pack
Changsha Sinocare Inc.
No.265 Guyuan Road, Hi-tech Zone,
410205 Changsha P. R. China.
XXXXXXXX
YYYY-MM-DD
YYYY-MM-DD
XXXXXXXXX
Transmitter Pack Sensor Pack
i3 Sensor Pack
Changsha Sinocare Inc.
No.265 Guyuan Road, Hi-tech Zone,
410205 Changsha P. R. China.
XXXXXXXXXXXX
(01)XXXXXXXXXXXXXX
(11)YYMMDD
(17)YYMMDD
(10)XXXXXXXXX
(21)XXXXXXXX
XXXXXXXX-A.1
Sinocare i3 CGM APP
Step 3: Attach sensor to the transmitter
a
XXXXXXXXXXXX
(01)XXXXXXXXXXXXXX
(11)YYMMDD
(17)YYMMDD
(10)XXXXXXXXX
(21)XXXXXXXX
XXXXXXXX-A.1
Peel lid completely off Sensor Pack.
Caution: The Sensor-Application contains a needle. Do not touch inside.
b
Place the Transmitter Pack on a hard, flat surface.
Line up blue mark on the Sensor-Applicator with
the mark on the transmitter tray.
c
Press the Sensor-Applicator down firmly into the tray
until you hear a click and it comes to a stop.
Sep Up Mobile App
1
Prepare Sensor Applicator
2
Get Ready
3
Apply Sensor
4
Start Monitoring
5
End Monitoring
6
d
Gently pull the armed
Sensor-Applicator straight up.
e
Now the Sensor-Applicator
is ready for insertion.