Table of Contents
Advertisement
3. Removal and Reassembly Procedure
3-(1)
Removal of Cabinet
1. Remove feet a) - (4) shown in Fig. 6.
2. Remove
the cord stopper
(5) of the signal cord as
shown in Fig. 6.
3. Remove
the
head
shell
and
main
weight
from
the
tonearm.
4. Move the tonearm
in direction of the center spindle as
shown in Fig. 7.
5. Lift the cabinet up, then remove the cabinet.
Note: When
the cabinet touches
the tonearm,
this may
damage the tonearm and the cabinet.
3-(2)
Reassembly of Cabinet
1. Set the ''CUEING"' switch to the ''DOWN"" position.
2. Set the tonearm as in Fig. 7.
3. Reassemble the cabinet.
Note: When remouting the feet (a) - (4) , mount the feet
having slipproof at the front side.
Fig. 7
3-(3)
Removal of Pickup Base Ass'y
1. Remove the anti-skating cover as shown in Fig. 8.
2. Remove screws
-
as shown in Fig. 9.
Fig. 8
ground
3-(4)
Reassembly of Pickup Base Ass'y
1. Push the switch lever by top of the finger as shown in
Fig. 10, then mount the pickup base ass'y.
So that, the stad of the arm lever is located as shown in
Fig. 11.
Note : Check
the ground as shown
in Fig. 9 to keep
away from the arm lever.
Fig. 9
QL-A200
—~4—
No. 2649
Advertisement
Table of Contents
