Cartridge Replacement; Removal Of Tonearm Assembly - JVC OL-F61 Service Manual

1. Remove the elevator.
Holding the tonearm up and away from the rest, turn
the elevator heigh adjusting screw fully counterclock-
wise and remove the elevator.
Note: Do not lose the elevator arm spring.
2. Remove five screws @) — © and remove the motor
and main gear.
3. Remove operating levers then the rods.
4. Remove three screws
— © and lift up the mecha-
nism.
Note: © Be careful not to deform the trip lever and
rods.
© During reassembly, do not mistake connection
of rods and levers.
Be sure to adjust the elevator height after re-
placement.
5-(2) Removal of Tonearm Assembly
1, Remove the mechanism base assembly.
2. Remove the arm lever.
(1) Loosen two screws @) — @ with a 2mm hexago-
nal wrench.
(2) Unsolder the signal leads on the circuit board.
3. Holding the tonearm, remove screw
@ and the stopper.
Note: During reassembly, position the arm lever
assembly by aligning the depressed part of the
lever with the positioning hole (see Figure 21).
Main Gear
Operating Motor
Section
AST
Fig. 19
Arm Lever
Rods Trip Lever
Stopper
Positioning Hole
6. Cartridge Replacement
after replacing the cartridge.
QL-F61
No. 2560
Plastic _—
Washer —= 4 "D
sd uw ZB \y
Nut
Fig. 22