airplex FOTON AUMAN Fitting Instructions

AUTOMOTIVE ACCESSORY
MANUFACTURE & DISTRIBUTION
FITTING INSTRUCTIONS
PLEASE READ INSTRUCTIONS COMPLETELY BEFORE INSTALLATION
FOTON AUMAN

Parts List:

2 x Centre mount plates
2 x M6 captive long reach 'plus-nut'
4 x M8 penny washer
4 x M8 bolt
4 x M8 spring washer
4 x M6 captive 'riv-nut'
6 x M6 x 25mm dome cap screw
6 x M6 flat washer
2 x alcohol cleaning wipe prep pads
1.
Locate the two roof M8 bolts above each door. Remove the factory bolts.
Temporarily mount the sunvisor to these holes using the M8 bolts, washers and
spring washers.
2.
Pull down on the side of the sunvisor to align the side of the sunvisor with the
edge of the door pillar. Make sure it does not interfere with the door
3.
Hold in position with masking tape. Repeat both sides. From the front of the
vehicle ensure that the sunvisor is aligned with windscreen. Adjust if required
and retape.
AIRPLEX INDUSTRIES LTD
21 Saleyards Road, Otahuhu, Auckland 1062, New Zealand
PO Box 11286, Ellerslie, Auckland 1542 New Zealand
PH +64 (9) 276-9826
info@airplex.co.nz
Fax +64 (9) 276-9836
www.airplex.co.nz
FIT1192
P/N SV151F
MADE IN NEW ZEALAND