Bosch mato Accu-Greaser 18V S Operating Instructions Manual page 11

Operating manual
Accu Greaser 18V-S
4 Set up
- Before first use, the battery must be charged.
For further use a charging time of approximately
0,5 to 1 hour suffices.
- Before charging ensure that the mains voltage
matches the specifications on the nameplate
of the charger.
- To charge the battery, remove from the handle of
the device and place in the charger.
- The charging process is started automatically.
- The green LED ON indicates that the battery
is being charged. - - -
- The red LED ON indicates that there is a fault
Of the charging process.
Observe the separate instruction for the charger.
- Filling with grease cartridges:
Only use standard (DIN 1284) 400g grease
cartridges.
- Filling with fill-device:
Set up the press with filling nipple on the fill-device.
During filling of the grease gun, keep pressed down.
- After that, insert the piston rod again completely into the
tubular body of the grease container.
- After filling of the grease gun at the filling nipple or at the
grease container, vent through a slight opening (1-1 ½ turns),
until bubble-free grease emerges.
- The grease gun is now operational.
- Press the START switch until grease emerges from the
nozzle.
- If the max. Operating pressure 400 bar the electronic overload
limiter of the device switches Prevents the motor from overloading.
In this case, the green operation LED does not light even if the
START switch is pressed.
Break off the lubrication process and establish the reason for the high
pressure build-up. It could, for example, be that the lubrication nipple,
the lubrication line or the depository is damaged or clogged.
The current battery capacity can be recalled by the red BAT button
at the battery pack.
- The temperature of the battery raises during use.
Before recharging the battery, leave to cool to room temperature,
otherwise it will not charge.
- The LED work light is switched on during use and goes out automatically approx. 10 seconds
after the device is switched off.
Attention: do not look directly into the switched-on light of the LED work light.
5 Maintenance and care:
The high-performance battery grease gun works maintenance free.
Regularly check the pressure-bearing components (high pressure hose) and the current-carrying
components (charger) for any damage or wear.
Defective parts must be replaced immediately with genuine parts.
Store Li-ion battery only in a fully charged state for a long time.
MATO GmbH & Co. KG / Benzstr. 16-24 / 63165 Mühlheim a. Main / Tel:+49(0)6108-906-0 / Fax:+49(0)6108-906-120
charge, fully charged
Hydraulic nozzle
G1/8"
Filler-
nipple
Grease
container
BAT-button
High pressure
hose
LED- Work light
START
switch
18V Battery
Battery capacity-
Indicator
11