Specifications - PROFECO 77467 Instruction Manual

21. To ensure the designed operational integrity of power tools, installed covers or
screws should not be removed.
22. Do not touch moveable parts or accessories unless the power source is
disconnected.
23. Use your tool at a lower input power than indicated on the nameplate,
otherwise the motor may be damaged and its operating efficiency reduced.
24. Do not wipe plastic parts with solvent. Solvents such as petrol, paint thinner,
alcohol, ammonia and chlorinated oil can damage and crack plastic parts.
Therefore, do not wipe them with such solvent. Wipe plastic parts with a soft
cloth slightly moistened with soapy water.

Specifications

Nominal voltage (V)
Rated power (W)
Rated speed (rpm)
Rated frequency (Hz)
Check the rating plate on the product, as it may change from one area to another.
Applications
• Sawing various types of timber and cutting pipes.
• Cutting mild steel plate, aluminium plate and copper plate.
• Cutting synthetic resins such as phenolic resin and vinyl chryed.
• Cutting thin and soft construction materials.
Before operation
1. Energy source
Make sure that the power source to be used corresponds to the power
requirements indicated on the product nameplate.
2. On/Off switch
Make sure that the power switch is in the OFF position. If the power plug is
plugged into a wall socket while the power switch is in the ON position, the
electrical equipment will immediately start to work, which may cause a serious
accident.
3. Extension cord
When the working area is separated from the power source, an extension cord
of sufficient length and rated capacity must be used. The extension cord shall
be kept as short as possible.
110
350
500-3000
50/60
7