About this document Target group of the instructions These instructions for Extension board 'Heating circuits' (EWP HK) are intended for the operator of the sys- tem. The PIN code for the operator is 9999. Validity of the instructions The documentation for the product Extension board 'Heating circuits' (EWP HK) is valid from November 2015.
For your safety Dangers and safety measures The assembly, installation, maintenance and servicing of Extension board 'Heating circuits' (EWP HK) may only be carried out by a specialist company. • Only carry out activities that are described in these instructions.
Product description Intended use The heating circuit extension board can only be used with the BRUNNER heating center BHZ or EWP Basis. Intended use also includes observing all information on personal and material hazards in these operating in- structions. Also comply with all country-specific standards and safety regulations.
Special adjustable functions Frost protection The Extension board 'Heating circuits' (EWP HK) is equipped with heating circuit frost protection. This has priority over all selected settings. As soon as the specified outside temperature (frost protection) is reached, the inactive circulation pumps of the heating circuits are automatically switched on. If the circulation pumps are already active, this function is omitted.
Configuration EWP HK Before configuring the heating circuit extension board, the BRUNNER central heating unit BHZ or the basic extension board must be configured. Example for the 3rd and 4th heating circuit; analo- gous for any other heating circuits For the configuration level of the EWP heating cir-...
Ulrich Brunner GmbH Notes on protecting your personal data Ulrich Brunner GmbH always endeavors to save and process only the personal data that are necessary and indispensable or that are required to be stored and processed by law. We strictly adhere to the requirements of the General Data Protection Regulation (GDPR) and the Federal Data Protection Act (BDSG and BDSG new).
EWP heating circuit no. 1; no. 1, extended home view (heating circuits 3 and 4) If more than one EWP HK is connected (here with EWP HK no. 2 with additional 2 heating circuits), these are displayed in the Home view and are visible in the “extended view”.
Page 17
= online with mybrunner Button for the home view of the BRUNNER boiler, the entire boiler control system Button for the home view of the heating system; the entire control of the heat consumers and heat gener- ators;...
Information and error messages Based on the highest industry standards, all BRUNNER expansion boards have a detailed safety concept. The controller not only regulates and monitors the current operating status, but also independently and continuously checks the function of all connected sensors, motors and mixers.
List of error codes The following is a list of error codes that can appear at Extension board 'Heating circuits' (EWP HK) and are shown on the display: Error text Error text Description Note to the operator Sensor H 1 -E06 defective or not connected.