Instructions Of Use; Auto Shut Off - Jata JEPL7000 Instructions Of Use

• Don't allow children play with the appliance. Keep the appliance out of
the reach of children.
• Thefabricsteameranditscordmustbekeptoutofthereachof
children under 8 years of age when it is switched on or cooling down.
• VERY IMPORTANT: Do not immerse in water or any other
liquid.
• Youmaygetsomesmokeand/orsmellsduringthefirstfewuses.
Thisiscompletelynormalinthiskindofappliances.
• Iftherestillrestsofwaterinthetank,itisduetothequalitycontrols
made in our production line.
• The cleaning and maintenance done by users, can not be done by
children without any supervision.
• If the power cord is damaged, it must be replaced by the manufacturer
orbyitsafter-salesserviceorsimilarqualifiedpersonnelinorderto
avoid a danger.

INSTRUCTIONS OF USE

• Before filling the tank, make sure that the steam button (1) is in position and the appliance is switched off.
To remove the water tank (5), press the extraction button (8) and with the iron resting on a surface, hold the
tank and pull the plate upwards.
• Open the lid of the water tank (5) and pour water into the water inlet (6), avoiding not to go over the indication
MAX. of the tank. The use of distilled water is recommended.
• Close the lid and place the iron on the tank, pressing until you hear a click.
• Plug the iron into the mains and leave it in vertical position.
• Press the ON switch (10), the light indicator will light up and blink, and it will remain fixed, then the iron has
reached the temperature (approximately 30 seconds)
• Press steam button (1) and slide down the locking system (7), towards the position
• Using the steam regulator (9) select the amount of steam you need (strong steam
• Care must be taken when using the appliance due to the emission of steam.

AUTO SHUT OFF

• The iron is protected by a safety system that produces its automatic disconnection after a time. (Approximately
8 minutes)
• When this happens, the light indicator (2) which remains illuminated whenever the plate is connected to the
network, shall start to operate in flashing mode, indicating that the iron has been disconnected.
• In order for the iron to be reconnected, it is enough to press the steam button (1). When this operation is carried
out, the pilot light (2) shall cease to operate intermittently.
10
.
, normal steam )