Installing The Keyboard Software - RCA pcstuff PC7630 Quick Start Manual

Installing the Keyboard software

Before you can take advantage of the many features your mouse and keyboard offer, you must install the driver.
The driver is in the installation CD that came packaged with your keyboard.
Windows 98/Me/2000/NT4.0/XP installation
1. Insert the installation CD into your disk drive.
2. Click the Start button and then click Run D:\
3. In the Run dialog window, type D:\setup, where "D" is the letter of your CD drive.
4. Click OK and follow the instructions on your screen to complete the installation.
Selecting the frequency channel
The Wireless keyboard and Optical Mouse operates on two
frequency channels. To prevent interference when using two
RF Optical Mice in close proximity a different frequency
channel should be used for each mouse. Refer to the
following to change the frequency channel for your keyboard
and mouse: Set the frequency channel on the receiver to 1 or
2. Set the frequency channel on the keyboard and mouse to 1
or 2.
The wireless keyboard and mouse ID code
Each keyboard and mouse is assigned a unique ID code when produced,
so the receiver only picks up the signal from your mouse and prevents
other Wireless keyboard or mouse radio signals from operating on your
computer. This feature can also be disabled, allowing other Wireless
pointing devices to operate on your computer. When the driver
installation is finished your computer reboots and the cordless mouse
window (shown on the right) appears.
CONNECT ID: Move the cordless mouse for a few seconds to establish a
connection, then click Connect ID. The unique ID code of your mouse is
recognized and another RF pointing device will not function on your
computer.
Exit: Click Exit if no other RF pointing devices are within 3 meters range
or if you want other RF pointing devices to be able to access your
computer.
Changing the Cordless mouse ID code
You can use a new cordless mouse on your computer without changing the keyboard receiver; you just need to change
the ID code. Refer to the following:
1. Press [Shift + Alt + F11] or [Shift + Alt + F12] to call up the Cordless Mouse ID Code window.
2. Move the cordless mouse for a few seconds to establish a connection, then click Connect ID.
3. The new ID code is connected and the cordless mouse window closes.
4. Click Exit to close the cordless mouse ID code window.
Connecting the wireless keyboard ID code
Manually establish a communication between the receiver and the
keyboard.
• Press any key on the keyboard
• Press the ID Connect button on the receiver: the green LED light shows
you that the keyboard ID is connected. If the green LED light is off then
the keyboard ID is disconnected.
3