Advertisement
Quick Start Guide
Aquavx™ (Legacy)
1. Wire Your Aquavx
1.
Drill holes in the unit enclosure for the power feed as well as for the amount of I/O wiring required. Affix
the necessary conduit fittings and assure proper waterproofing.
2.
Wire 100-240VAC power to the Line (Black), Ground (Green), and Neutral (White) terminals on the
#1700-0101 power supply at the top of the panel.
3.
Attach the black wire from the power supply BAT- terminal to the negative battery post.
4.
Wire I/O connections using the screw terminals on the quick disconnect plugs in their respective
channels. There is a quick reference diagram below the connectors on the swing panel. For more
detailed information, reference the schematic drawings and online manual found at www.cattron.com.
When ready, power on the unit with the power switch to the right of the I/O connectors.
1.
3.
Configuration Sheets and Manuals Are Available at Cattron.com
Nimble: 9M01-9207-A001 | EN-2023-11-V4
2.
4.
Power
Switch
Advertisement
Table of Contents
Related Manuals for Cattron Aquavx
Summary of Contents for Cattron Aquavx
- Page 1 There is a quick reference diagram below the connectors on the swing panel. For more detailed information, reference the schematic drawings and online manual found at www.cattron.com. When ready, power on the unit with the power switch to the right of the I/O connectors.
- Page 2 If your system is preconfigured, the I/O will arrive programmed per the configuration sheet you provided to us. If it is not preconfigured or if changes are required, the legacy Aquavx can be programmed via a locally connected PC, remotely over the cellular network, or the keypad on the unit. Programming instructions can be found in the manual.
- Page 3 Quick Start Guide Aquavx™ (Legacy) Wired Aquavx Configuration Sheets and Manuals Are Available at Cattron.com Nimble: 9M01-9207-A001 | EN-2023-11-V4...
Need help?
Do you have a question about the Aquavx and is the answer not in the manual?
Questions and answers