Advertisement
Quick Links
INSTALLATION & OPERATING INSTRUCTIONS
Product Name:
General information
• This luminaire must be installed in accordance with the latest edition of the IET Wiring Regulations and local Building Regulation
by a qualified competent person.
• The mains power supply must be turned off before inspection, installation or removal of the luminaire, ensuring that the supply is
locked off to prevent inadvertently switching the supply on.
• It is the installer's responsibility to ensure that the installation is suitable for the total load of the luminaire(s). The supply cable
fuses/circuit breakers must be correctly rated for the electrical load and taking into account for any transient inrush currents that
may occur.
• It is the installer's responsibility to ensure that the environmental operating and storage conditions are complied with and that any
fire risks are considered.
• Do not perform insulation strength or insulation resistance tests on the installation with the luminaire(s) connected, this can
damage the luminaires and give erroneous readings.
• Do not loop-in supply cables at the luminaire supply terminals unless there is provision for 2-way connection at the terminals.
• The light source contained in this luminaire must only be replaced by Tamlite Lighting or an appointed service agent.
• Emergency lighting luminaires must be installed and maintained in accordance with the emergency lighting standard BS 5266-1.
• To ensure that the product warranty remains valid, the luminaire must be installed and maintained in accordance with these
installation instructions and the product must not be modified in any way.
Luminaires marked with this symbol must not be covered with thermally insulating material.
This symbol on covers over light sources indicates dangerous live parts do not operate the luminaire with this cover removed.
Dimensions
100.00mm
Warning!
This LED tape MUST be connected to a suitable driver.
Please refer to the driver's instructions.
Page 1 of 2
Tamlite Technical
Stafford Park 12,
Telford, Shropshire,
TF3 3BJ
+44(0)1952 292441
technical@tamlite.co.uk
Document No: V1
A (mm)
FX241NW / FX241WW
1000
FX242NW / FX242WW
2000
FX243NW / FX243WW
3000
FX244NW / FX244WW
4000
FX245NW / FX245WW
5000
A
B (mm)
C (mm)
FX246NW / FX246WW
10
2000
FX247NW / FX247WW
10
2000
2000
FX248NW / FX248WW
10
FX249NW / FX249WW
10
2000
FX2410NW / FX2410WW
10
2000
24V DC
A (mm)
B (mm)
C (mm)
6000
10
2000
7000
10
2000
8000
10
2000
9000
10
2000
10000
2000
10
C
ta
IP20
IK03
0°C to 25°C
Advertisement
Related Manuals for Tamlite FX241NW
Summary of Contents for Tamlite FX241NW
- Page 1 • Do not loop-in supply cables at the luminaire supply terminals unless there is provision for 2-way connection at the terminals. • The light source contained in this luminaire must only be replaced by Tamlite Lighting or an appointed service agent.
- Page 2 Continue to install the tape, ensuring good contact with the mounting surface. NOTE: Driver shown for reference only. Connect to an appropriate power supply with reference to the instruction sheet supplied with the power supply. Page 2 of 2 Tamlite Technical Stafford Park 12, Telford, Shropshire, TF3 3BJ...