Step 4. Verify System Operation; Battery Pull Tab; Apply Power; Test Watering - Rain Bird SST600IN Setup & Operation Instructions

Step 4. Verify System Operation

Battery Pull Tab


To activate the internal battery, grasp the yellow pull-tab on
the side of the timer and pull it out.
 
NOTE: If the timer doesn't have AC power for more than
a week, the time needs to be reset. This conserves battery
power for future outages. Program details are kept in long
term non volatile memory so they are not lost even after
long power outages.

Apply Power

Indoor Model

Plug the transformer into a wall outlet.
Outdoor Model

Turn on main power supply or plug the power cord into a
waterproof receptacle.
 
NOTE: Do not plug the timer into a socket that is controlled
by a secondary ON/OFF light switch or GFI outlet.

Test Watering

A
Turn the dial to the ZONE 1 position.
" "
Press the WATER 1 ZONE NOW button. The zone will start
watering for the default run time of 10 minutes and the green
LED corresponding to WATER 1 ZONE NOW button turns on.
B
To stop watering before time is up, press the WATER 1 ZONE
NOW button a second time. The green LED corresponding
with the WATER 1 ZONE NOW button will turn off.
C
Repeat the above steps until all connected zones have been
tested.
D
Replace the wiring bay cover on front of the unit.
REMOVE
PULL-TAB
INDOOR PLUG IN
TRANSFORMER
3 3
SST User Manual
SST user manual (EN) web.indd 3
TEST WATERING
OUTDOOR
APPLY
POWER

Optional Accessories

Rain Sensor

Connect an optional Rain Sensor to the Timer
A
Remove the wiring bay cover at the bottom of the unit.
B
Remove the yellow jumper wire from the terminals marked
RAIN SENSOR on the terminal block.
REMOVE
JUMPER WIRE
 
NOTE: Do not remove the jumper wire unless connecting a
rain sensor. The timer will not function if the jumper wire is
removed and a rain sensor is not connected.
C
Connect the two wires from the sensor to the RAIN SENSOR
terminals.
CONNECT
WIRES
10/11/2016 8:17:25 PM