Table of Contents
Advertisement
10. Place the sprocket cover so that the bolt and pin
on the tool body meet their counterparts on the sprocket
cover.
Fig.15
► 1 . Sprocket cover 2. Bolt 3. Pin
11.
Turn the lever clockwise until the sprocket cover is
secured then return it to the original position.
Fig.16
► 1 . Lever 2. Sprocket cover
Make sure that the saw chain does not loose and the
saw chain can be moved smoothly back and forth. If
necessary, adjust the tension of the saw chain by refer-
ring to the section for adjusting saw chain tension.
1
2
3
1
2
12 ENGLISH
Adjusting saw chain tension
CAUTION:
A chain which is too loose can
jump off the bar and it may cause an injury or
accident.
The saw chain may become loose after many hours
of use. From time to time check the saw chain tension
before use.
If the saw chain is loose, adjust the saw chain tension.
1.
Pull the lever up.
Fig.17
► 1 . Lever
2.
Turn the lever counterclockwise a little to loosen
the sprocket cover lightly. The chain tension is adjusted
automatically.
Fig.18
► 1 . Sprocket cover 2. Lever
1
2
1
Advertisement
Table of Contents
