Table of Contents
Advertisement
12
3. [POWER LEVEL] control
This adjusts the output wattage of the power amp.
VT15: less than 0.2W – 15W
VT30: less than 0.2W – 30W
VT50: less than 0.2W – 50W
VT100: less than 0.2W – 100W
NOTE: The power level setting is not saved in the program.
This allows you to output at a range of volume levels without impairing the fat and
warm sound (distinctive of classic tube amps) that is produced when you raise the
drive of the Valvetronix amp's power stage. Even when you're practicing in a small
room, you can play without damaging the listener's eardrums or compromising the
great tone.
4. EXTERNAL SPEAKER OUT jack
You can connect a guitar speaker cabinet to this jack.
NOTE: Sound will not be output from the internal speaker if you use the EX-
TERNAL SPEAKER OUT jack.
NOTE: The VT15 and VT30 don't have this jack.
Important: To ensure that your system works correctly, you must observe the fol-
lowing points.
a) Don't use an external speaker whose impedance is other than 8 ohms.
b) Don't connect a speaker whose rated input capacity is less than 50 watts
(100 watts for the VT100). The speaker may be destroyed if you ignore
this caution - not recommended!
c) You must use a speaker cable to connect an external speaker. Don't use a
shielded cable like the one you use to connect a guitar to an amp.
d) You must turn off the power before connecting the cable. Connecting the
cable while the power is turned on may damage your amp.
5. LOOP SEND jack, RETURN jack
These are loop jacks that you can connect to your external effect processor. Connect
the SEND jack to the input of your external effect processor. Connect the RETURN
jack to the output of your external effect processor.
NOTE: The VT15, VT30 and VT50 don't have this jack.
Hide quick links:
Advertisement
Table of Contents
