Emtec SSD Power Plus X160 Manual

X150 2.5'' SATA
STOP! IMPORTANT INFORMATION.
READ THE FOLLOWING CAREFULLY BEFORE USING THE EMTEC SSD.
KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Safety & Handling Instructions:
Avoid touching the Emtec SSD's connector. Handle the Emtec SSD using its edge or frame. Do not remove, damage or cover any
product labels. Removal of such labels voids the warranty.
Ensure the Emtec SSD does not exceed maximum operating temperature as specified in the Emtec SSD product sheet. Exercise
caution when removing the Emtec SSD from the Desktop/Notebook as the Emtec SSD may have heated up.
Keep the Emtec SSD away from sinks, drinks, bathtubs, showers, rain and other sources of moisture.
Moisture can cause electric shocks with any electronic device. Do not disassemble, crush, short circuit or incinerate the Emtec SSD
as it may cause fire, injury, burns or other hazards.

Installation Guidelines:

Before installing the Emtec SSD please take all necessary precautions to comply with the Desktop/Notebook manufacturer's
handling instructions.
1. Power off the Desktop/Notebook and disconnect the main power cord from the wall outlet. If the Desktop/Notebook uses battery
power, remove the battery.
2. Refer to the manufacturer's instructions for details on how to remove the computer's outer case, and where the SATA connectors
are located on the motherboard.
3. According to the machine type:
a) Desktop: Connect the Emtec SATA SSD to the SATA data cable and insert the SATA cable into the SATA connector on the
motherboard. Connect the SATA SSD drive to the SATA power connector.
Once you have installed the Emtec SATA SSD into the Desktop close the case and then reconnect power to the Desktop.
b) Notebook: Slide the Emtec SSD's SATA connector into the Notebook's SATA connector. If you are installing the Emtec SSD on a
Notebook, it may be necessary to re-install the battery before reconnecting the power.
4. SATA uses a point-to-point protocol; therefore, no setting of jumpers for master/slave functionality is required.
5. Power on the system to verify that the installation was successful.

Additional Safety Instructions:

Keep the Emtec SSD drive away from direct sunlight, moisture and temperature extremes. Do not bend, flex or drop your Emtec
SSD drive. The user is responsible for complying with all environmental, safety and other usage specifications outlined in the Product
Manual located at http://www.emtec-international.com
Technical Support: Visit Emtec's website.

Disposal Instructions:

Do not dispose of the Emtec SSD with unsorted waste. Improper disposal may be harmful to the environment and human health.
Please refer to your local waste authority for information on return and collection systems in your area.

Data backup:

To prevent data loss, we strongly recommend to proceed at least to a backup of your data. Any data loss or corruption while using
SSD is the sole responsibility of the user. Under any circumstances will the manufacturer be held liable for compensation or data
recovery.

Warranty:

This SSD has 3 years warranty from date of purchase. Within the warranty period, we will repair or replace your SSD in case of
material or functional defect. We do not take any responsibility in case of data loss. It is suggested that one regularly backs up their
personal data.
The warranty does not apply:
1) For damages caused by natural disaster.
2) If the SSD has been repaired or dismounted by unauthorized persons.
3) If the product has been destroyed voluntarily or unvoluntarily.
4) If the warranty label or capacity information have been changed or removed, if the serial number does not appear clearly or does
not match.
5) If the SSD was bought from unauthorized channel.
6) If the warranty period has expired.