Table of Contents
Advertisement
Fault
, , ,
,
+ power level and
audible signal
and signal tone
/
/
/
Home Connect is not
working properly.
Animations on the
displays
25.3 Normal noises from your appliance
An induction hob may sometimes cause noises or vi-
brations, such as buzzing, crackling, hissing noises, fan
noises or rhythmic noises.
Disposal
26 Disposal
26.1 Disposing of old appliance
Valuable raw materials can be reused by recycling.
Unplug the appliance from the mains.
1.
Cut through the power cord.
2.
Dispose of the appliance in an environmentally
3.
friendly manner.
Information about current disposal methods are
available from your specialist dealer or local author-
ity.
Cause and troubleshooting
The odour filter is saturated or the saturation indicator lights up even though the filter has
been replaced.
Change the filter and reset the filter saturation indicator. You can find additional informa-
▶
tion about this in the section entitled
→ "Cleaning and servicing", Page 20.
The electronics have overheated and one or all of the cooking zones have been switched
off.
Wait until the electronics have cooled down sufficiently. Then touch any button on the
▶
control panel.
There is hot cookware in the vicinity of the control panel. This may cause the electronics to
overheat.
Remove the cookware. The fault display goes out shortly afterwards. You can continue to
▶
cook.
There is hot cookware in the vicinity of the control panel. The cooking zone has been
switched off to protect the electronics.
Remove the cookware. Wait a few seconds. Touch any button. When the fault display
▶
goes out, you can continue cooking.
The cooking zone has overheated and has been switched off to protect the work surface.
Wait until the electronics have cooled down sufficiently before switching the cooking
▶
zone back on.
The cooking zone has been operating continuously for an extended period.
Individual safety switch-off is switched on. Touch any button to switch off the display so
▶
that you can set the cooking zone.
The operating voltage is incorrect and outside of the normal operating range.
Contact your energy supplier.
▶
The hob is not connected correctly.
Disconnect the hob from the mains. Connect the hob in accordance with the circuit dia-
▶
gram.
Demo mode is activated.
Switch off demo mode in the basic settings.
▶
Different causes are possible.
Go to www.home-connect.com.
▶
In certain circumstances, the hob can perform self-maintenance tasks, e.g. a firmware up-
date, optimisation or troubleshooting.
Wait until the process is complete and only then switch the hob on.
▶
This appliance is labelled in accord-
ance with European Directive
2012/19/EU concerning used elec-
trical and electronic appliances
(waste electrical and electronic equip-
ment - WEEE).
The guideline determines the frame-
work for the return and recycling of
used appliances as applicable
throughout the EU.
Disposal en
23
Advertisement
Table of Contents
