Checking The Engine Oil Level; Starting The Engine - Toro 74360 Operator's Manual

Add the correct amount of gas stabilizer/conditioner
to the gas.
Note: A fuel stabilizer/conditioner is most effective
when mixed with fresh gasoline. To minimize the
chance of varnish deposits in the fuel system, use fuel
stabilizer at all times.
Gasoline/Alcohol blends
Gasohol (up to 10 percent ethyl alcohol, 90 percent
unleaded gasoline by volume) is approved for fuel use
by the engine manufacturer. Other gasoline/alcohol
blends, such as E85, are not approved.
Gasoline/Ether blends
Methyl Tertiary Butyl Ether (MTBE) and unleaded
gasoline blends (up to a maximum of 15 percent MTBE
by volume) are approved for fuel use by the engine
manufacturer. Other gasoline/ether blends are not
approved.
Fuel Gauge
Use the fuel window below the operator to verify the
level of gasoline before filling the tank (Figure 8).
1. Fuel gauge window
Filling the Fuel Tank
1. Shut the engine off and set the motion controls to
the park position. Raise the seat so the gas tank is
visible while fueling.
2. Clean around the fuel tank cap and remove the cap.
3. Add unleaded regular gasoline until the body of the
tank is full but fuel does not fill the neck of the
tank (Figure 9). This space in the neck of the tank
Figure 8
allows gasoline to expand. Do not fill the fuel tank
completely full.
4. Install the fuel tank cap securely. Wipe up any
gasoline that may have spilled.
2
1
1. Gas tank body
2. Gas tank neck

Checking the Engine Oil Level

Before you start the engine and use the machine, check
the oil level in the engine crankcase; refer to Checking
the Oil Level in the Engine Maintenance section.

Starting the Engine

1. Sit down on the seat and move the motion controls
outward to the park position.
2. Disengage the blades by moving the blade control
switch to Off (Figure 10).
1. Control panel
16
4
3
G005302
Figure 9
3. Fill to here, approximately
4. Gas tank opening
G005056
1 1
Figure 10
2. Blade control switch—Off
position
2 2