AEG LTR8A631E1 User Manual page 25

The ProSense is not available with some
programmes, such as Wool/Silk,
programmes with short cycles and
without washing phase.
11.13 Opening the Lid when the
programme operates
CAUTION!
If the temperature and level of the water
in the drum are too high, the lid lock
indicator stays on and you cannot
open the lid.
To open the lid proceed as follows:
1. Press the button On/Off
seconds to deactivate the appliance.
2. Wait for some minutes and then open
carefully the lid.
3. Close the lid.
4. Activate the appliance and set the
programme again.
11.14 Opening the Lid when the
delay start is active
While the delay start operates, the appliance
lid is locked.
To open the appliance lid:
1. Press button Start/Pause
The lid lock indicator
2. Open the appliance lid.
3. Close the lid and press button Start/
Pause .
The delay start continues.
11.15 End of cycle
When the programme has finished, the
appliance stops automatically. The acoustic
signal operates (if it is active).
In the display comes on and the lid locked
indicator goes off.
The indicator of Start/Pause
off.
for some
.
goes off.
button goes
1. Press button On/Off
appliance.
After five minutes from the end of the
programme, the energy saving function
automatically deactivates the appliance.
When you activate the appliance again,
the display show the end of the last set
programme. Turn the programme knob to
set a new cycle.
2. Remove the laundry from the appliance.
3. Make sure that the drum is empty.
4. Keep the door ajar, to prevent mildew and
odours
11.16 Draining water out after end
of cycle
The washing programme is completed,
but there is water in the drum:
The drum turns regularly to prevent the
creases in the laundry.
The lid lock indicator
locked.
You must drain the water to open the lid:
1. If necessary, decrease the spin speed.
2. Press the Start/Pause
The appliance drains the water and spins.
3. When the programme is completed and
the door lock indicator
can open the door .
4. Press On/Off
deactivate the appliance.
The appliance drains and spins
automatically after approximately18
hours.
11.17 Stand-by option
The Stand-by function automatically
deactivates the appliance to decrease the
energy consumption when:
• You do not use the appliance for 5
minutes before you press the button Start/
Pause
to deactivate the
is on. The lid stays
button.
goes off, you
some seconds to
ENGLISH 25