Advertisement
Band Packs
40m Pack
Parts Pack 40m
L1
L2
L3
L4
L5
XTAL
TRIMMER
Capacitor
30m Pack
Parts Pack 30m
L1
L2
L3
L4
L5
XTAL
TRIMMER
Capacitor
Important
The Rooster is a relatively easy to build transceiver BUT you need to carefully follow the
instructions, do not move on a stage until you are sure that you have completed the
previous stage correctly and fully. All parts must be fitted neatly and their leads trimmed
flush.
I cannot stress strongly enough that unless you follow the instructions and make
sure that each part is fitted correctly as indicated in these instructions you will not
successfully complete the kit.
Get familiar with the main PCB.
The photos are showing the 40m Board, when there is a difference the instructions for the
30m build will show the different steps needed. The difference is really the crystals and the
Low pass filter values.
Rooster CW Transceiver Rev6
1
100uH
1
10uH
1
1uH
1
1uH
1
3.3uH
3
40m Crystal
1
4-20PF Trimmer (Red)
1
100pf
1
100uH
1
6.8uH
1
0.68uH
1
0.68uH
1
3.3uH
3
30m Crystal
1
6-40PF Trimmer (Yellow)
1
470pf
Page 4 of 33
See Instructions for colours
See Instructions for colours
See Instructions for colours
See Instructions for colours
See Instructions for colours
X1, X2, X3
C26
C29
See Instructions for colours
See Instructions for colours
See Instructions for colours
See Instructions for colours
See Instructions for colours
X1, X2, X3
C26
C29
12/02/2024
Advertisement
