Advertisement
Make sure yours are fitted flush to the board and that the leads are trimmed flush on the
back of the board.
Stage 7: Front end bandpass filter
We now will fit the last two crystals, Y1 and Y2 that are in your band specific bag
They are both the same and either can be fitted in either position.
Stage 8: RIT Control
The RIT tune control.
control is still positioned correctly, when
happy solder the two outer pins. Trim the
leads flush with the board.
Rooster CW Transceiver Rev6
First remove the nut and washer from the
front of the control, make sure the 3 pins
are not bent over and insert it onto the
board. Push the control down so the body
is flush to the board. It must be flush to
the board or the front panel will not fit!
Solder the centre pin first and check the
Page 18 of 33
When fitted the board
should look like this.
Not much more to do
now.
12/02/2024
Advertisement
