Installation - Dometic MILENCO DM-3100 Installation Instructions Manual

INSTALLATION

A. Prepare for Installation
1.  U sing a #2 Phillips screwdriver, remove pan
head screw (4 mm x 20 mm) from mirror hous-
ing. See (FIG. 2).
FIG. 2
2. Remove mirror housing from assembly.
3. Using a #3 Phillips screwdriver, unthread (2)
larger screws. See (FIG. 3).
FIG. 3
B. Installation
1.  A ssemble mirror clamps to vehicle mirror, slid-
ing "foot" of clamps between vehicle mirror and
vehicle mirror housing. See (FIG. 4).
 S lide clamps in as far as possible for max-
imum clamp contact.
Large Screws
3
FIG. 4
2. Position blind spot mirror on vehicle mirror for
maximum viewing.
3. While pressing heel of clamps against vehicle
mirror (FIG. 4), tighten (2) large screws, using a
#3 Phillips screwdriver, securing mirror clamps
to vehicle mirror. See (FIG. 5).
FIG. 5
 Do NOT overtighten screws. Do-
ing so could damage vehicle mirror housing.
4. Assemble mirror housing to mirror, aligning
screw hole in housing with screw hole in mirror.
5. Using a #2 Phillips screwdriver, assemble screw
to housing and tighten, securing housing to mir-
ror. See (FIG. 6).
Heel
Foot