Preparation Of The Oven; Installation Hardware - Electrolux EI30BM55HS Installation Instructions Manual

5 TOOLS RECOMMENDED FOR
INSTALLATION
• Phillips Screwdriver
• Electric Drill
1 5 3
• / ", / " and / " Drill Bits
2 8 32
• 1 1 / " Wood Bit or Metal Hole Cutter
2
(if metal cabinet is used)
• Saw to cut exhaust opening (if needed)
• Protective Drop Cloth for product and range -
you may also use carton for protection
• Scissors
• Pencil
• Measure
• Tape

6 INSTALLATION HARDWARE

The INSTALLATION HARDWARE items
bag. All items are in a bag packed below the oven.
Item Name
q Wood Screw 5 x 35 mm
3
w Toggle Bolt / "
16
Top Cabinet Screw 5 x 93 mm
e
r Flat Washer 30 mm diameter
t Grommet
Tapping Screw 4 x 8 mm
y
u Exhaust Damper Assembly
i Grease Filter
Rear Cushion
o
a Installation Instructions
s Top Template
Wall Template
d
9
Parts shown not to common scale.
INSTALLATION INSTRUCTIONS
➀ ➅
- are in a small
316902446
316902447
316902448
Use with metal cabinets. Surround
the power cord opening. Cut to fi t.
Figure 4

7 PREPARATION OF THE OVEN

1. Open the bottom of the carton, bend the carton flaps
back and tilt the oven over to rest on plastic foam pad.
Lift carton off oven and remove all packing materials,
Installation Instructions, Wall Template, Top Template,
Turntable and Turntable Support; however, DO NOT
REMOVE THE WAVEGUIDE COVER, which is located
on the ceiling in the oven cavity. SAVE THE CARTON AS
IT MAY MAKE INSTALLATION EASIER.
2. CHECK THE OVEN.
Check the oven for any damage, such as misaligned or
bent door, damaged door seals and sealing surfaces,
broken or loose door hinges and latches and dents inside
the cavity or on the door. If there is any damage, do not
operate the oven and contact your dealer or Electrolux
AUTHORIZED SERVICER.
Quantity
6
4
2
2
1
4
1
2
1
1
1
1
3
Mounting Plate
Figure 5
E