Sears Kenmore ELITE 65.69642 Use And Care Manual page 26

Microwave hood combination
Table of Contents

Advertisement

Available languages

Available languages

REPLACING THE COOKTOP AND OVEN LIGHTS
1. Unplug microwave oven or disconnect power.
2. Remove the bulb cover mounting screw and
carefully remove
the cover.
3. Remove the burnt-out bulb(s) and replace with
10W low-voltage halogen capsule bulb(s)
(PN 8169418).* Use a soft tissue to handle
bulb(s), or wear a cotton glove. Do not touch
bulb(s) with your bare fingers.
4. Replace the bulb cover and mounting screw.
5. Plug in microwave oven or reconnect power.
1. Unplug microwave oven or disconnect power.
2. Remove the two vent grille mounting screws
located above the cover
(the two outer screws).
3. Tip the grille forward, then lift out to remove.
[
4. Lift the bulb cover.
5. Remove the burnt-out bulb by squeezing the wire
clip together, pulling to the
right and lifting. Replace
the bulb with a lOW low-
voltage halogen capsule
bulb (PN 8169418).* Use a
soft tissue to handle the
lamp, or wear a cotton
glove. Do not touch lamp
with your bare fingers.
6. Close the bulb cover.
7. Slide the top of the vent grille into place. Push the
I
] bottom until it snaps into
place. Replace the
mounting screws.
8. Plug in microwave oven or reconnect power.
* To order bulbs call 1-800-366-7278
and follow the
instructions and telephone prompts you hear.
26

Advertisement

Chapters

Table of Contents
loading

Table of Contents