Fault Causes/Troubleshooting; Instructions In The Event Of Faults - SAMIX BR200 Instruction Manual

8

Fault causes/troubleshooting

8.1

Instructions in the event of faults

Fault
The SAMIX
®
switched on.
The SAMIX BR200 switched off
®
due to an overload.
Tab. 3: Faults and troubleshooting
After the device is switched off and the fault has been eliminated, the SAMIX
works again normally.
Following troubleshooting perform a function check in accordance with the details
under "Function check or initial operation" in the enclosed document "Installation
Qualification (IQ)".
In the case of serious faults, note the device type and contact the manufacturer.
NOTICE
In the case of serious faults, only send in the drive head of the SAMIX
GmbH. Unscrew the drive head by slackening the wing bolt on the bottom of the device foot
(see Fig. 20).
NOTICE
After an operation period of approximately 500 hours, the contact carbon brushes of the
SAMIX BR200 may be worn. The contact carbon brushes are replaced during the regular
®
maintenance work performed by SAMIX GmbH.
The inspection and maintenance work to be performed for documentation within the frame-
work of a QM system can be obtained from customer service upon request.
Troubleshooting
BR200 cannot be Check whether there is supply voltage and the connector is correctly
connected to the socket.
Set the adjusting knob to "0".
Observe a cooling period of 30 minutes.
Fault causes/troubleshooting
SAMIX GmbH
BR200
®
BR200 to SAMIX
®
35