North Star 5044310 Owner's Manual page 63

Step 18 – Suction Hose Routing
• Add hose clamp and connect one end of the suction hose to the Valve.
Torque to 77 in.-lb.
• Set outrigger leg to down position and tip beam to vertical position.
• Route hose through hose guide as shown below (note location of suction and
high-pressure hoses through hose guide). Zip tie suction hose to high
pressure hose so they are side-by-side. Tip splitter into vertical position a few
times and check hoses are not being crushed when the beam returns to
horizontal position.
• Add hose clamp and connect remaining end of suction hose to Return Line
Filter Fitting. Torque to 77 in.-lb.
Fittings Needed from Parts Bag:
Valve to Filter
Hose Clamp
Qty 2
1131 Only
Assembly Instructions
Hose Clamp
High Pressure Hose
Suction Hose
Hose Guide
Zip Tie
Hose Clamp
Return Line Filter Fitting
63
• Flat Blade
Suction Hose
High Pressure Hose
Tools Needed
Screwdriver
Zip Tie