Samsung SM-X716B Repair Manual page 72

14
Slide the opening pick back and forth along the bottom right edge to slice through
the adhesive.
Leave the opening pick inserted in the bottom right edge side to prevent the
adhesive from resealing.
Do not insert the opening pick more than 1 mm as this could damage the
•
internal circuitry.
Be careful when inserting the opening pick too deeply as this could damage
•
the internal circuitry, leading to problems such as abnormal operation of the
screen.
If you have trouble creating a gap, heat the microwaveable heating bag
additionally, and apply it on the screen to further soften the adhesive. When
reheating, it should be heated no longer than 30 seconds.
15
Place the suction cup in the left of the bottom edge of the screen, lift upwards, and
then insert the opening pick in the gap at the bottom left edge.
Be careful when inserting the opening pick too deeply as this could damage the
internal circuitry, leading to problems such as abnormal operation of the screen.
In case of the bottom edge side of the screen, very weak circuits are located very
close to the edge. Just insert only about 1 mm.
If you have trouble creating a gap, heat the microwaveable heating bag
additionally, and apply it on the screen to further soften the adhesive. When
reheating, it should be heated no longer than 30 seconds.
Disassembly and Assembly
72