Panasonic NE-7910 Service Manual page 17

2.
CAUTION
SERVICEMEN SHOULD REMOVE THEIR WATCHES WHENEVER WORKING CLOSE TO OR REPAIRING THE
MAGNETRON :
w
(B)
Remove the magnetron with the shielded case, permanent. magnet, choke coils and 500pF capacitors because they are
one assembly. . = :
Discharge the high voltage capacitor, (See page 15)
Remove air guide.A by removing the 2 screws holding it to the oven cavity.
Remove two high voltage leads from filament terminals. .
Remove two screws holding thermal cutout to magnetron.
Remove four screws holding the magnetron to waveguide.
between. the waveguide and the magnetron.
° ff \
i —
MAGNETRON
(Fig. 14)
ie
Disconnect 10-pin connector and 2-pin connector.
this service manual. :
Remove three screws holding the digital programmer circuit to the escutcheon base, (See fig. 15)
Remove 8 screws holding the digital programmer circuit to the escutcheon base. (See fig. 17)
escutcheon base.