Braun BC13 Quick Setup Manual

BC13
Weather station
Quick set-up guide
For detailed information refer to
the full user manual available at
www.braun-clocks.com/pages/warranty
or scan this code:
Braun helpline
Should you have a problem with your
product, please check your local service
centre at:
www.braun-clocks.com
www.braun-watches.com
Certain trademarks used under license from the
Procter & Gamble Company or its affiliates.
3
2 1
6
A
Battery installation
1. Remove the battery doors.
4
2. Insert 2xAA size new batteries in the main unit
and 2xAAA size new batteries in the sensor as
indicated in the battery compartments (
5
3. To pair the main unit with the sensor, press the
RESET key (
and then press the RESET key (
battery compartment of the sensor.
4. In some cases the main unit and the sensor will
not pair immediately. You can reset the main unit
and the sensor again as described in the above
section. Due to the atmospheric disturbance, the
best reception often occurs during night time.
5. Close the battery doors.
Only use new alkaline batteries from a reputable
brand.
Setting the time
1. Slide the TIME SETTING / NEUTRAL / ALARM
SETTING switch ( ) to the TIME SETTING position.
2. Press the '+' or '-' key (
3. Slide the TIME SETTING / NEUTRAL / ALARM
SETTING switch to the NEUTRAL position to return
the normal display and save the settings.
Setting the alarm
1. Slide the TIME SETTING / NEUTRAL / ALARM
SETTING switch ( ) to the ALARM SETTING
position.
2. Press the '+' or '-' key (
3. Slide the TIME SETTING / NEUTRAL / ALARM
SETTING switch to the NEUTRAL position to return
the normal display and save the settings.
Using the alarm function
1. Enable the alarm by pushing the ALARM ON / OFF
slider ( ) up (so the green indicator is visible).
4
2. To disable the alarm and snooze function, push
the ALARM ON / OFF slider down.
Using the snooze function
Tap the SNOOZE touch button ( ) to stop the alarm
and activate the snooze function. When the snooze
function is activated, the alarm will automatically
start again after 5 minutes. The snooze function will
B
not stop unless the ALARM ON / OFF SLIDER is
pushed down
).
2 A
) at the back of the main unit first,
3
) inside the
B
1
) to set the desired value.
5
1
) to set the desired value.
5
6