Mitsubishi Electric MSZ-AP60VG Operating Instructions Manual page 14

● OPERATING INSTRUCTIONS ●
W
i-Fi Interface Setting Up (VGK Type Only)
This Wi-Fi interface, communicates the status information and controls
the commands from the MELCloud by connecting to the indoor unit.
Front panel
Wi-Fi interface
Wi-Fi Interface Introduction
EN
No. Item
1 MODE switch
2 RESET switch
3 ERR LED (Orange)
4 NET LED (Green)
5 MODE LED (Orange)
6 UNIT LED (Green)
3
4
5
6
2
(1) MODE switch
• The MODE switch is used for selecting modes in configurations.
(2) RESET switch
• Hold down the RESET switch for 2 seconds to reboot the system.
• Hold down the RESET switch for 14 seconds to initialize the Wi-Fi interface
to the factory default.
When the Wi-Fi interface is reset to the factory default, ALL the con-
figuration information will be lost. Take great care in implementing this
operation.
EN-13
Front panel
Wi-Fi interface
Description
It selects modes.
It resets the system and ALL settings.
It shows the network error state.
It shows the network state.
It shows the Access point mode state.
It shows the indoor unit state.
INTERFACE
Wi-Fi
XXXXXXXX
MODEL
MAC : XXXXXXXXXXXX
ID : XXXXXXXXXX
SSID : XXXXXXXXXXXX
KEY : XXXXXXXXXXXX
:
VOLTAGE
:
CURRENT
ERR
MITSUBISHI ELECTRIC CORPRATION
NET
MODE
UNIT
MODE
RESET
>PP<
WiFi.ASSY DWG No.
XXXXXXXXXXX
MADE IN CHINA XXXXXXXXXX
1
1
Open the front panel and remove the Wi-Fi interface.
2
Set up a connection between the Wi-Fi interface and
the Router. Refer to the SETUP MANUAL and SETUP
QUICK REFERENCE GUIDE provided with the unit.
For SETUP MANUAL, please go to the website below.
https://www.melcloud.com/Support
3
Put the Wi-Fi interface back and close the front panel
after the setup is completed.
4
For MELCloud User Manual, please go to the website
below.
https://www.melcloud.com/Support
Note:
• Ensure that the Router supports the WPA2-AES encryption setting before
starting the Wi-Fi interface setup.
• The End user should read and accept the terms and conditions of the Wi-Fi
service before using this Wi-Fi interface.
• To complete connection of this Wi-Fi interface to the Wi-Fi service, the Rout-
er may be required.
• This Wi-Fi interface will not commence transmission of any operational data
from the system until the End user registers and accepts the terms and con-
ditions of the Wi-Fi service.
• This Wi-Fi interface should not be installed and connected to any Mitsubishi
Electric system which is to provide application critical cooling or heating.
• Please write down the information regarding the Wi-Fi interface setting on the
last page of this manual, when you set up this Wi-Fi interface.
• At the time of relocation or disposal, reset the Wi-Fi interface to the factory
default.
Mitsubishi Electric's Wi-Fi interface is designed for communication to
Mitsubishi Electric's MELCloud Wi-Fi service.
Third party Wi-Fi interfaces cannot be connected to MELCloud.
Mitsubishi Electric is not responsible for any (i) underperformance of a
system or any product;
(ii) system or product fault; or (iii) loss or damage to any system or product;
which is caused by or arises from connection to and/or use of any third
party Wi-Fi interface or any third party Wi-Fi service with Mitsubishi Electric
equipment.
For the latest information regarding MELCloud from Mitsubishi Electric
Corporation, please visit www.melcloud.com.