Visioneer OneTouch 9320 Installation Manual page 54

50 V O
ISIONEER NE
T 9320 USB S
OUCH CANNER
2. If the dotted line is not exactly where you want it, put the pointer
on the line and drag the mouse.
For example, if you want the scan to include a border around the
image, you can drag the dotted line to be slightly larger than the
autotrimmed area.
To use the pointer to drag the line, make sure the pointer button is
selected at the top of the window.
3. When the trimmed area is what you want, click Scan.
To manually set the output size for an item:
1. To scan the entire item on the glass, click Same as Original. No
sections are trimmed.
2. To set the output size yourself, click Same as Original to remove
the checkmark.
The settings for the output size become active.
3. Put the pointer on the image and drag the mouse to enclose the
section you want in the scanned image.
As you drag the mouse, a dotted box appears on the image and the
size settings change to reflect the new output size area. You can also
type in the size settings boxes.
Width and Height—The measurements of the final image after
I
it's scanned; for example, if you plan to print the image on a
standard paper, the width and height are 8.5 and 11.0 inches.
Units—Units of measurement for the new area; click the drop-
I
down arrow and choose new units if you want.
Resolution—The dots-per-inch (dpi) setting for the new area.
I
Scale—The amount of enlargement or reduction of the image to
I
fill the width and height measurements; for example, if you
select a small area and have set the width and height to a paper
size, the scale automatically increases to enlarge the small image
so it's the same size as the paper.
I G
NSTALLATION UIDE