Auto Power Off; Restore Factory Default Settings; Troubleshooting - Alesis RECITAL 61 User Manual

Auto Power Off

In order to save energy, the Recital 61 Digital Piano will automatically shut down after 30 minutes if it
is not used.
To enable or disable the Auto Power Off function:
1. Press the Metronome and Lesson buttons at the same time to enter Advanced Function
Mode. The button LEDs will be lit.
2. Following the diagram on page 7, use the key marked Auto Pwr to enable or disable the Auto
Power Off function.
3. Press both the Metronome and Lesson buttons again to exit Advanced Function Mode.

Restore Factory Default Settings

To restore your Recital 61 to the factory default settings, press and hold the Layer and Lesson
buttons for 5 seconds. All settings will be reset to their default values.
Note: Recital 61 cannot be in Advanced Function Mode when you restore it to the factory default
settings.

Troubleshooting

Problem
The speakers produce a
pop sound whenever
the power is turned
on/off.
The speakers do not
produce sound when
the keys are played.
The speakers are
producing noise or
interference.
Certain notes produce
the wrong pitch.
The notes sound weak
or distorted.
Possible Cause and Solution
This is normal and is no cause for alarm.
Check if the master volume is set too low or if headphones are
plugged into the Headphone Output. The speakers will be muted if
there are headphones plugged into the Headphone Output.
If the issue is still occurring, press and hold the Layer and Lesson
buttons for 5 seconds to factory reset the voice volume settings of the
unit.
Using a mobile phone in close proximity to the Recital 61 Digital Piano
may produce interference. To prevent this, turn off the mobile phone
or keep it away from the piano.
Make sure that the transpose value is set to 0. If that does not work,
then press and hold the Layer and Lesson buttons for 5 seconds to
restore the factory default settings.
If the keyboard is being powered with batteries, make sure new
batteries are installed.
13