EPS INGENICO DESK 2600 User Manual

INGENICO DESK 2600 USER MANUAL
For a contactless card
F2 Menu
Paper feed
F
Cancel
For magnetic card

Guidelines for replacing the card reader ribbon

Open the paper feed section by following the instructions in the
image below. Load the paper roll so that the paper strip rotates
from the bottom to the top. After inserting the paper roll, stretch the
tape to the top of the terminal, while holding the paper, close the
cover.
1
EPS LT, UAB
Int. k. 302413851 VAT m.k.
LT10000481191
Adjust
2
3
+370 5 203 2772
info@eps.lt
w w w . e p s . l t
F3 Menu
The
menu
marked with the NFC symbol. Keep the
card close to the reader during the entire
Confirm
Insert the card horizontally with the chip
For chip card
Charging socket
Connect the wire and make it follow the cable path as
shown in the picture.
Savanoriu PR. 123A LT-
03150 Vilnius Lithuania
Magnetic stripe cards
The card can be scanned either from left
to right or from right to left. (When
scanning, the magnetic strip must be on
top).
Contactless cards
Hold the card firmly against the area
transaction.
Chip cards
facing up and do not remove it until a
message appears that the transaction
was completed successfully.